Water-inc HP-RO-1000 User Manual download pdf (Page 4)

3. Mounting the Faucet

A. Pre-assemble the base. The rubber washer should be

in place below the base. The two toggle bolts should be

inserted through the base and the rubber washer. The

bolts are screwed into the spring-loaded toggle.

B. Place the base assembly over the hole in the sink. The

two toggles should pass through the hole far enough to

spring fully open. If they are not open, unscrew the bolt

until the toggle moves down to clear the sink.

C. Look down through the base for this step. Before

tightening the bolts, determine the correct rotation of the

off from the bolt heads. Use Figure 5 to help determine

the best position for your installation.

Through the hole in the base, hold the toggle in position

while tightening the bolt. The spring loaded toggle

will contact the bottom of the counter top and hold in

position. Do not fully tighten. Repeat for second toggle

bolt.

Tighten the two bolts evenly. DO NOT OVERTIGHTEN.

Tighten only far enough to prevent the base from

rotating when the faucet is rotated in place.

D. Attach large diameter 3/8" (red) drain tube to the larger

long enough to reach the drain clamp in Step 7.

E. Locate the 1/4" red brine tube from the right side of the

system head assembly. Route the tube through the

faucet base and connect to small barb on the faucet.

Make certain that the tube is not kinked or stressed

once the head assembly is mounted.

quick connector onto end of threads.

G. Wet end of 3/8" blue tube. Push into bottom of

connector. Tug gently to be sure connection is

complete. This tube should be long enough to reach the

top right side of the RO Assembly.

H. Check that the O-ring is in place on the faucet. Feed

the remaining 3/8" tubes through the base. Hold the

left) while pushing down. The faucet will drop into the

base. Push down on the faucet and rotate forward (to

seated and the faucet held securely in position.

I. Insert the spout into the top opening. Hold in position

and screw the collar onto the base.

NOTE: If the faucet handle is not in the correct

position, remove the faucet, loosen the toggle

bolts and reposition the base. Tighten the

toggle bolts. Then reinstall the faucet.

Base

Black Rubber

Washer

Folds Upward

Figure 3

Base

Black Rubber

Washer

Will Spring Open

O-ring Seat

Figure 4

Handle Faces This Direction

45°

Notch For Faucet

Blades Must Be Held

When Tightening

Notch For Faucet

Figure 5

Figure 6

INSTALLATION continued

O-ring

4 • HP-RO-1000 Undersink Reverse Osmosis System

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Water-inc HP-RO-1000 User Manual Page 4

Comments to this Manuals

Related products and manuals for Accessories for water Water-inc HP-RO-1000